Z Compression Correction? - Form 3/3+ - Formlabs Community Forum
4.9 (446) · $ 10.00 · In stock
I’m printing directly on the build platform (V2) and am having trouble getting the height of the parts close to size. I started with the default settings and my part came out 0.9mm too high. I adjusted the z compression correction to 0.0mm and my part is still 0.2mm too high. How to I adjust it further to compensate? Also, how do I avoid the edge highlighted in the second image where the part sits on the build plate? Thanks. (I’m printing directly on the platform for speed of print and surfac
PDF) 3D Printing a Mechanically-Tunable Acrylate Resin on a Commercial DLP-SLA Printer
Automated 3-D Printed Arrays to Evaluate Genotoxic Chemistry: E-Cigarettes and Water Samples
PDF) Characterization of mechanical stiffness using additive manufacturing and finite element analysis: potential tool for bone health assessment
Overcompression
Polymers, Free Full-Text
Orientation of large flat parts - General Discussion - Formlabs Community Forum
Glazing of 3D-Printed Silica to Reduce Surface Roughness and Permeability
PDF) A Short Review on 4D Printing
Prints resolution/distortion in area of supports and surfaces facing platform - Form 3/3+ - Formlabs Community Forum
Why are first layers so different in 0.1 & 0.05mm layer height? - Form 3/3+ - Formlabs Community Forum
